Harwin Z80-294 Manual do Utilizador Página 2
- Página / 3
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
IS-29 Issue: 4 Date: 16.12.2010 C/Note: 11057 Page 2 of 3
TOOL PREPARATION
1. Check that the tool is in the open position.
2. Place positioner assembly onto retainer ring with the 2 socket head screws lined up with
tapped holes.
3. After positioner assembly is seated against retainer ring, tighten socket head screws with
9/64 Inch (3.57mm) hex key.
4. Check Table 1 for the correct crimp tool setting of the wire size you wish to crimp.
5. Remove the safety clip from the selector knob (do not discard).
6. Lift and turn the selector knob until the correct crimp tool setting is lined up with the “Sel.
No.” arrow. Lower the selector knob, ensuring the locating peg lines up with a notch.
7. Install the safety clip back into the selector knob.
CRIMPING PROCEDURE
1. Ensure that the wire to be crimped is within the specified range of sizes for the contact and
the crimp tool. Failure to use the specified wire size will result in poor quality crimps and
possible tool damage.
Table 1
Contact Crimp Type
Wire Gauge
(AWG)
Stranding
(mm)
Crimp Tool
Setting
Minimum
pull-off force
M80-338 Power Crimp 18 19/0.26 7 50N
M80-328 Power Crimp 18 19/0.26 7 50N
M80-329 Power Crimp 20 19/0.20 7 50N
M80-339 Power Crimp 20 19/0.20 7 50N
2. Cut the end of the cable to be terminated so that there is a clean cut end (Figure A). Strip
the cable to the correct length (Figure B) using a PTFE Wire stripper, preferably with
adjustable rotating cutter. This should result in all the strands lying together neatly. If the
lay of the strands is disturbed, it may be re-imposed with a slight twist.
Clean cut
Ø1.10mm max (22-28 AWG)
Ø1.80mm max (18-20 AWG)
RIGHT WRONG
2.00 ±0.15mm (M80-XXX)
3.75 ±0.25mm (K36XX)
Figure A Figure B
Ø1.60mm Max (20 AWG)
Ø1.80mm Max (18 AWG)
5.0 ±0.25mm
Manuais e produtos relacionados com Ferramentas Harwin Z80-294
Ferramentas Harwin Z80-299 Manual do Utilizador
(4 páginas)
(4 páginas)
Ferramentas Harwin M80-94X Manual do Utilizador
(3 páginas)
(3 páginas)
Ferramentas Harwin Z90-293 Manual do Utilizador
(5 páginas)
(5 páginas)
Ferramentas Harwin Z80-255 Manual do Utilizador
(9 páginas)
(9 páginas)
Ferramentas Harwin Gecko Manual do Utilizador
(3 páginas)
(3 páginas)
Ferramentas Harwin Z30-021 Manual do Utilizador
(7 páginas)
(7 páginas)
Roland PH-3 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Pedał muzyczny Roland PH-3.
Dostarczamy 1 pdf podręczników Roland PH-3 do pobrania za darmo według typów dokumentów: Instrukcja Właściciela
Comentários a estes Manuais